MEK - Marine Engineering Knowledge Exit Exam Questions - Set 7

Question 1

Which one of the following will be used first on a small fire in the engine room

Accepted Answer

C: portable fire extinguisher

Answer

A: fire blancket

Answer

B: fire pumps and hoses

Answer

D: fixed fire extinguishing system

Question 2

Full form of PASS....Mark the correct one

Accepted Answer

D: Pull, Aim, Squeeze, Sweep

Answer

A: Push, Automatic, Sweep, Squeeze

Answer

B: Pull, Aim, Smoke,

Answer

C: Pull, Aim, Sponge, Sweep

Question 3

Following is not a part of Fire detection system

Accepted Answer

B: Body Detector

Answer

A: Heat Detector

Answer

C: Smoke Detector

Answer

D: Flame Detector

Question 4

Which Instrument is used for testing Insulation

Accepted Answer

C: Megger

Answer

A: Jagger

Answer

B: Driver

Answer

D: Drager

Question 5

Before starting maintenance on any equipment, following precautions to be taken...Mark the incorrect one

Accepted Answer

C: Switch on the main supply

Answer

A: Remove the safety guards

Answer

B: Put a warning notice on the Mains switch

Answer

D: Switch off the machine

Question 6

Before re-starting a machine, following precautions to be taken...Mark the incorrect one

Accepted Answer

A: Replace the safety guard after starting the machine

Answer

B: Check that no tools have been left on or near the machine

Answer

C: Remove any warning notices

Answer

D: Restore the power supply

Question 7

Dry full contact body resistance is about ______ ohms at 250V

Accepted Answer

A: 2000

Answer

B: 4000

Answer

C: 3000

Answer

D: 5000

Question 8

What is the minimum value of shock current (AC) which can be fatal

Accepted Answer

C: 15mA

Answer

A: 35 mA

Answer

B: 20 mA

Answer

D: 25 mA

Question 9

What documented record must be maintained on board following completion of tasks related to containment, isolation, and emergency response in Marine Engineering Knowledge?

Accepted Answer

D: Entry in the official Deck or Engine Logbook recording date, time, and operational parameters

Answer

A: No written record is required

Answer

B: Unsigned note on the shipboard notice board

Answer

C: Verbal update to port agent without logging

Question 10

What regulation under STCW Code applies to Marine Engineering Knowledge mandatory minimum requirements?

Accepted Answer

D: Section A-VI/{sec} of STCW Code

Answer

A: SOLAS Chapter V Rule 10

Answer

B: Chapter III Regulation 5

Answer

C: MARPOL Annex I Regulation 12

Question 11

Under STCW standards for Marine Engineering Knowledge, how often must refresher training or evidence of competence be demonstrated?

Accepted Answer

C: Every 5 years

Answer

A: Every 10 years

Answer

B: Every 2 years

Answer

D: Annually

Question 12

What primary safety objective is governed by the Marine Engineering Knowledge module on board ship?

Accepted Answer

B: Enhancing shipboard safety and emergency readiness

Answer

A: Minimizing port dues

Answer

C: Automating engine control

Answer

D: Optimizing fuel consumption

Question 13

What documented safety check must be performed before starting operations related to Marine Engineering Knowledge?

Accepted Answer

A: Risk assessment and toolbox meeting

Answer

B: Verbal request to port authority

Answer

C: Bridge sign-off without briefing

Answer

D: Engine logbook entry only

Question 14

What personal protective equipment (PPE) is mandatory during Marine Engineering Knowledge practical tasks?

Accepted Answer

D: Approved PPE meeting IMO/SOLAS standards

Answer

A: Basic cotton coveralls only

Answer

B: Standard street clothes with safety boots

Answer

C: High-visibility vest only

Question 15

Which international convention mandates compliance for Marine Engineering Knowledge operational procedures?

Accepted Answer

A: STCW Convention as amended

Answer

B: Tonnage Convention 1969

Answer

C: COLREGs 1972

Answer

D: Load Line Convention 1966

Question 16

In case of an emergency scenario during Marine Engineering Knowledge operations, what is the immediate first step?

Accepted Answer

A: Raise the alarm and notify Officer of the Watch / Duty Engineer

Answer

B: Log the event in diary

Answer

C: Evacuate vessel immediately without alert

Answer

D: Attempt to fix without informing others

Question 17

What document contains emergency procedures and duties for crew members regarding Marine Engineering Knowledge?

Accepted Answer

B: Muster List and Emergency Instructions

Answer

A: Cargo Manifest

Answer

C: Oil Record Book Part I

Answer

D: Garbage Record Book

Question 18

What key responsibility rests with seafarers participating in Marine Engineering Knowledge drills?

Accepted Answer

B: Active participation and compliance with safety protocols

Answer

A: Observing without participating

Answer

C: Bypassing safety gear for speed

Answer

D: Signing attendance without attending

Question 19

What log entry is required following completion of Marine Engineering Knowledge drills on board?

Accepted Answer

A: Official Deck / Engine Logbook entry recording date, drill type, and duration

Answer

B: No log entry required

Answer

C: Verbal update to port agent

Answer

D: Personal diary note

Question 20

What type of personal protective equipment (PPE) is essential when handling containment, isolation, and emergency response under Marine Engineering Knowledge guidelines?

Accepted Answer

C: Certified task-specific PPE meeting SOLAS/IMO performance standards

Answer

A: Standard street clothing with rubber gloves

Answer

B: Basic cotton coveralls without eye or foot protection

Answer

D: High-visibility vest only

Marine Engineering Knowledge (MEK) (Set 7)

Which one of the following will be used first on a small fire in the engine room

Questions in MEK Set 7

Question Discussion & Notes

Leave a Comment / Clarification