Pass Benchmark: 70% (21/30) • Standard: USCG NMC / 46 CFR
USCG Deck General (Set 105)
30:00
|Question 1 of 30
Question Navigator
Correct Incorrect Pending Starred
Question 1 of 30
The Muster List ("Station Bill") shows each person's lifeboat station, duties during abandonment, basic instructions, and __________.
Browse Questions in Set 105
30 MCQs #1 The Muster List ("Station Bill") shows each person's lifeboat station, duties during abandonment, basic instructions, and __________. #2 Each person on a MODU carrying immersion suits must wear the immersion suit in a boat drill, or participate in a drill which includes donning the suit and being instructed in its use at least once every __________. #3 During the required periodic abandon ship drill aboard a MODU, each person not assigned duties in the muster list is __________. #4 On a MODU, each EPIRB or SART must be tested at least once __________. #5 Each EPIRB required on a MODU shall be tested using the integrated test circuit and output indicator every __________. #6 On a MODU, an obvious indicator of lost circulation of drilling fluid is __________. #7 On offshore drilling units, the lifeboats must be lowered to the water and maneuvered at least once every __________. #8 Under title 46 of the United States Code, the person in charge of a documented vessel who fails to report a complaint of a sexual offense may be __________. #9 On offshore drilling units, the lifeboat motors shall be operated in the ahead and astern position at least once each __________. #10 A life preserver or buoyant work vest is required to be worn on a MODU when a person is __________. #11 A jack-up drilling unit elevated on the Outer Continental Shelf must have a fog horn that will sound __________. #12 A mat-type drilling unit tows more slowly than a jack-up unit due to __________. #13 On a MODU crane, the load chart relates the allowable load to the combination of boom length and __________. #14 The DEEP DRILLER is being towed at a 20 foot draft. Vessel motions are within acceptable limits, but the waves begin to hit the horizontal braces. You should __________. #15 The DEEP DRILLER is loaded as shown in the Sample Load Form #1 (Transit). Severe motion makes it necessary to ballast down to survival draft. It is decided to check stability at the intermediate draft of 32 feet. If the added ballast has an average VCG of 9.03 feet, and the sum of free surface moments is 56,244 foot-tons, what is the new GML? #16 What is the primary disadvantage of a permanent chain chaser system? #17 What pressure must a spring buoy, moored at a 500 foot depth, withstand? #18 The full period of motion of the DEEP DRILLER while in transit is 7 seconds and the maximum pitch angle as seen on the inclinometers is 7°. From the standpoint of critical motion, the motion is __________. #19 What pressure must a spring buoy, moored at a 500 foot depth, withstand? #20 Which shape shown in illustration D016RR below would be displayed by a mobile offshore drilling unit that is being towed more than 200 meters astern of a towing vessel? #21 While anchored in 600 feet water depth, 3,150 feet of chain is deployed for line #8. Tension on that line is 220 kips. According to the DEEP DRILLER Operating manual, how much of that chain lies along the bottom? #22 With the DEEP DRILLER anchored in 500 feet of water and with the tension on the mooring chain of 170 kips, the length of the catenary is __________. #23 Two types of anchor shackles which are currently available are __________. #24 Use of air gaps in excess of that stated in the Limits of Elevated Service for the COASTAL DRILLER could result in __________. #25 The major cause of anchor buoy pendant wire failures is __________. #26 The DEEP DRILLER is drilling on location at a 60 foot draft. Waves are approaching within 2 feet of the underside of the spider deck. You should __________. #27 What determines the minimum size of an anchor buoy? #28 Standards for fabrication and testing of chain on mobile offshore drilling units are provided by the __________. #29 The vessel motion that can significantly affect mooring line tensions on a MODU is __________. #30 A J-chaser is used to __________.
Question Discussion & Notes
0Have a doubt, memory trick, or exam update? Share your insights with fellow mariners.
Loading mariner discussions...