Pass Benchmark: 70% (21/30) • Standard: USCG NMC / 46 CFR
USCG Safety & Environmental Protection (Deck) (Set 39)
30:00
|Question 1 of 30
Question Navigator
Correct Incorrect Pending Starred
Question 1 of 30
According to the SOLAS regulations, lifeboat falls must be renewed at intervals of how many years?
Browse Questions in Set 39
30 MCQs #1 According to the SOLAS regulations, lifeboat falls must be renewed at intervals of how many years? #2 The pivot pin at the base of a sheath-screw boom davit must be __________. #3 In illustration D016SA below, the line indicated by number 4 is connected to which of the following? #4 In illustration D012SA below, what will be released when pulling on line number 5? #5 At a speed of 6 knots the fuel aboard a survival craft should last __________. #6 The lever shown in illustration D013SA below is operated when a lifeboat is which of the following positions? #7 In illustration D016SA below, what number indicates the frapping line? #8 In illustration D012SA below, what is the mechanism that will release the tricing pendant? #9 A sea anchor is __________. #10 When a sea anchor for a lifeboat is properly rigged, it will __________. #11 When you stream a sea anchor, you should make sure that the holding line is __________. #12 What is the purpose of limber holes? #13 Aluminum lifeboats are subject to damage by electrolytic corrosion (the aluminum being eaten away). In working around boats of aluminum you must be very careful __________. #14 In order to prevent galvanic corrosion, an aluminum boat must be insulated from the davits and gripes. Which of the following is acceptable as an insulator? #15 Stretchers are fitted in lifeboats to provide a __________. #16 The grab rail of a metal lifeboat is normally located __________. #17 The purpose of air tanks in a lifeboat is to __________. #18 The tops of the thwarts, side benches, and the footings of a lifeboat are painted which color? #19 In painting a lifeboat following its overhaul, which parts must be painted bright red? #20 In order for the automatic lifeboat drain to operate properly __________. #21 A person referring to the stern sheets of a lifeboat is speaking of __________. #22 Frapping lines _________. #23 What is TRUE concerning frapping lines? #24 The tricing pendants should be released __________. #25 The purpose of the tricing pendants is to __________. #26 On open lifeboats, the purpose of the wire stretched between the davit heads is to __________. #27 Lines passed around the falls to hold the boat while passengers are boarding are __________. #28 Blocks and falls used as lifeboat gear must be designed with a minimum safety factor of __________. #29 Which statement is TRUE concerning lifeboat gripes? #30 When using a hand held smoke signal from a lifeboat, you should activate the signal __________.
Question Discussion & Notes
0Have a doubt, memory trick, or exam update? Share your insights with fellow mariners.
Loading mariner discussions...