Type a keyword to start searching...

Use ⌘K or Ctrl+K to search from anywhere
Pass Benchmark: 70% (21/30) Standard: USCG NMC / 46 CFR

USCG Engineering Safety & Environmental Protection (Set 29)

|
Question 1 of 30
Question Navigator
Correct Incorrect Pending Starred
Question 1 of 30

Coast Guard Regulations (46 CFR) require how many 15 pound carbon dioxide fire extinguishers to be installed in the boiler room of an 8,000 horsepower steam propelled vessel?

Browse Questions in Set 29

30 MCQs
#1 Coast Guard Regulations (46 CFR) require how many 15 pound carbon dioxide fire extinguishers to be installed in the boiler room of an 8,000 horsepower steam propelled vessel? #2 Before making any welded repairs to the internals of a vessel's fuel tank in a U.S. port, the tank must be examined by __________. #3 The size of the fire hydrant hose connections must be either 1 1/2 inches or __________. #4 According to Coast Guard Regulations (46 CFR), a 10 pound dry chemical extinguisher is equivalent to a __________. #5 What Coast Guard Regulations apply to the equipment of a fireman's outfit? #6 Your vessel was damaged in a collision and one compartment has partially flooded. The vessel has free communication with the sea with water flowing in and out as the vessel rolls. Which of the following is the most important factor contributing to free communication loss of stability? #7 You are part of a team to overhaul a fire that was just extinguished in the crew lounge. Where is the nearest fire axe to break apart the furniture? Illustration SF-0045 #8 On the illustrated fire control plan, what emergency equipment is located in the scullery? Illustration SF-0045 #9 You are being directed to a fire in the lower engine room, port side, frame 127. What machinery is found in that exact location? Illustration SF-0044 #10 The term "oily mixture", as defined in the Pollution Prevention Regulations (33 CFR) includes __________. #11 The Exclusive Economic Zone extends from the baseline of territorial sea of the United States seaward ___________. #12 Exemption or partial exemption from compliance with any requirement in the Oil or Hazardous Material Pollution Prevention Regulations prescribed in (33 CFR 155) may be granted by the __________. #13 Which of the methods shown in the illustration is the correct way to fit shoring? Illustration SF-0016 #14 In the illustration shown, the sea painter is identified as item number _____. Illustration SF-0043 #15 What term is listed on a Material Safety Data Sheet (MSDS) to describe a chemical that can produce a life-threatening or seriously disabling health hazard? #16 Which of the following statements is TRUE concerning life jackets? #17 Kapok life jackets require proper care and should NOT be __________. #18 In the event of a fire, the doors to a stair tower must be closed to prevent the spread of fire by ____________. #19 In figure 1 of the illustration, fire would spread to compartment "B" by __________. Illustration SF-0013 #20 Which of the following conditions is a symptom of heat stroke? #21 When administering mouth-to-mouth rescue breathing to an adult, you should breathe at the rate of how many breaths per minute? #22 When required to work in an area where explosive gases may accumulate, you should use hand tools which are __________. #23 The fire extinguishing agent dispensed by the unit shown in the illustration is produced by __________. Illustration SF-0020 #24 If the items shown in the illustration are burning, this fire would be a Class __________. Illustration SF-0001 #25 The equipment shown in the illustration is a __________. Illustration SF-0012 #26 The component shown in the illustration would be installed in which of the following types of fire detection systems? Illustration SF-0004 #27 What would be the most probable cause for a high-pressure alarm to be activated in a low-pressure CO2 fixed fire extinguishing system? #28 When re-entering an engine room that has been flooded with CO2, the investigating team should initially __________. #29 To operate a carbon dioxide extinguisher having the type of head shown in the illustration, you would __________. Illustration SF-0008 #30 Which of the following statements is FALSE concerning the proper procedure in handling a fire hose?

Question Discussion & Notes

0

Have a doubt, memory trick, or exam update? Share your insights with fellow mariners.

Leave a Comment / Clarification

By posting, you agree to our Terms & Moderation Policy.

Loading mariner discussions...